Harley Sportster signal problem.?
I went out and put 36″ ape hangers on my 02 1200 sportie. Everything went fine. All controls work all electronics are fine. Start it up cruise down the road 10 feet and my turn signals are not blinking they turn on but don’t blink. Pull the bike back in turn it off. I check all the fuses and lines no problem. turn on the acc. turn signals blink. Turn bike on, no blinking. Turn on emergency they blink. Turn on one or the other no blinking. Turn off bike they blink. What did I do? What little gremlin crawled into my bike?
I have done this twice before switching between standard to drag then to apes. With no problem I got these loger apes and now I have problems. I checked the ground. If you read the damn question the problem only exists when the scoots running!! So the wiring is GOOD like I said. Everything is tight!! At least the first anwser tried. The 2nd was just being retarded.
with 36″ apes you might have a amp load prob, wowsa those are big ole bars man wow. check that you dont have one burnt out sounds stupid but it is harleys way of telling you got a prob in the tsm. do you have the right bulbs in the sockets two contacts in front and one in rear.also check your pin placement in your connector. right is 123 left is 456 black is in 1 and 6 purple are in 2 and 5 blue are 3 and 4. if all else fails after that check your pin placement in your duetch connectors for your switch housing too. last but not least you may need a load equalizer. k good luck.
Harley Sportster Ape Hangers
|
|
Harley Davidson – 2008 XL 1200N Sportster 1200 Nightster $11.98 This popular officially licensed Harley Davidson motorcycle model is sure to inspire a passion for the open road for all ages…. |
|
|
Burly Brand Handlebar Installation Kit for 12in. Ape Hangers B30-1007 $173.59 Complete installation kit for 12in., 14in., 16in. and 18in. Burly Ape hangersKits include black braided steel brake line, extended clutch cable, extended throttle cables and all necessary wiringKits for FL are for non-ABS models only and include black braided steel brake line, extended clutch cable and wiring for main harness, radio and CBFL kits use stock throttle-by-wire harness and fits Street … |
|
|
Burly Brand Handlebar Installation Kit for 16in. Ape Hangers B30-1001 $172.88 Complete installation kit for 12in., 14in., 16in. and 18in. Burly Ape hangersKits include black braided steel brake line, extended clutch cable, extended throttle cables and all necessary wiringKits for FL are for non-ABS models only and include black braided steel brake line, extended clutch cable and wiring for main harness, radio and CBFL kits use stock throttle-by-wire harness and fits Street … |
|
|
1 Ape Hangers Medium & Wide Chrome Bonanza Bars KIT Harley-Davidson 1990 & Later $379.95 These handlebars will fit on 1990-2012 Dyna, Softail and Sportster models and mount to the stock risers and use stock controls. Included are the Handlebars, Stainless Steel cables, Stainless brake lines for SINGLE Front Disk brakes and the wiring harness extensions. After ordering, you MUST call us to provide us with the following information about your bike so that we put the correct kit togeth… |
|
|
1 Ape Hangers Medium & Wide Chrome Bonanza Bars Harley-Davidson 1990 & Later $117.95 These handlebars will fit on 1990-2012 Dyna, Softail and Sportster models and mount to the stock risers and use stock controls. Extended cables and brake lines are needed. We offer all lengths of stainless lines…. |
|
|
1 Ape Hangers High & Wide Chrome Bonanza Bars Harley-Davidson 1990 & Later $117.95 These handlebars will fit on 1990-2012 Dyna, Softail and Sportster models and mount to the stock risers and use stock controls. Extended cables and brake lines are needed. We offer all lengths of stainless lines…. |